This video will help you remove and install a new clutch to your M109R with all the proper adjustments.
To upgrade to the 2011-Present clutch for 2006-2009, this is puts you into the later year clutch.
Contact us to order a kit.
If you need to remove your pan this will show you how to do it. If you have a bad clutch and see a lot of the fibers in the basket, you will NEED to do this to check your sump screens. If they are dirty, you can either clean them or replace them.
A "how to" on changing the final drive fluid on the M109R. The crush washer part number is - 09168-14002 This is the same for the oil pan bolts as well.
This is a known problem that they drive shafts come with minimal amounts of grease in the earlier years. It is good to check this and service it every now and then. You will only need wheel bearing grease, snap ring plyers and a new dust seal. The part number is below.
Drive Shaft Dust Seal - 09283-0601
When doing a valve check and having to change the shims, rebuilding an engine or simply a transmission fix, this is how you time the M109R motor. Even if you only remove the rear head for the transmission, you still need to time it starting at the front cylinder. You have to set it to F/T with the cams in the proper spot and then time the rear.
Cleaning the distribution block on the Arnott air ride.
We use cookies to analyze website traffic and optimize your website experience. By accepting our use of cookies, your data will be aggregated with all other user data.